Silo Removal And Adjustment - Piper SBH-2-P Installation And Operating Manual

Each self-leveling unit has internal springs that are field-adjustable without the use of tools. Remove the
lids and lift out the self-leveling dispenser through the top to expose springs. Adjust springs equally on
each side following the diagram below. Adjustment is set at the factory for most stainless steel wax base
plates.
If the top dish does not remain at a constant level as dishes are added or removed, then
adjustments should be made as follows:
• Allow unit to cool down before removing dishes from dispenser, then remove dispenser
from unit.
• If the dish level is rising as dishes are added, disengage springs following the diagram
below.
• If the dish level is falling as dishes are added, engage additional springs following the
diagram below.
• Spring configuration must remain symmetrical for proper movement.
Note: Spring sections should look like one of the above
illustrations. ALL sections should be configured the same.

SILO REMOVAL AND ADJUSTMENT

SPRING ARRANGEMENTS
5