Table of Contents
Advertisement
Quick Links
HEATED BASE AND PLATE DISPENSERS
SBH-2-P, SBH-2-WB, SBH-2-PWB, SBH-3-P, SBH-3-WB
For service information call 800-544-3057
Please have the following information available before calling. Information can be found
on the identification/certification tag:
•Model Number
•Serial Number
•Date of Purchase
•Part Description and number as shown in parts list
This manual contains important safety information concerning the maintenance, use and operation of this product.
Failure to follow these instructions could result in damaging equipment, voiding the warranty, serious injury or even death.
Installation and Operating Manual
IMPORTANT INFORMATION
READ BEFORE USE
Piper Products, Inc
300 South 84th Avenue
Wausau, WI 54401
Phone: 715-842-2724 . FAX: 715-842-3125
Advertisement
Table of Contents
Summary of Contents for Piper SBH-2-P
- Page 1 HEATED BASE AND PLATE DISPENSERS SBH-2-P, SBH-2-WB, SBH-2-PWB, SBH-3-P, SBH-3-WB Installation and Operating Manual For service information call 800-544-3057 Please have the following information available before calling. Information can be found on the identification/certification tag: •Model Number •Serial Number •Date of Purchase •Part Description and number as shown in parts list...
- Page 2 WARNING RISK OF FIRE OR ELECTRIC SHOCK DO NOT OPEN WARNING, TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REPAIR SHOULD ONLY BE DONE BY AUTHORIZED SERVICE PERSONNEL ONLY The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage”...
-
Page 3: Table Of Contents
INSTALLATION START-UP AND OPERATION MAINTENANCE GENERAL CLEANING SILO REMOVAL AND ADJUSTMENT TROUBLESHOOTING GUIDE SBH-2-P AND SBH-2-WB EXPLODED VIEW SBH-2-PWB EXPLODED VIEW SBH-3-P AND SBH-3-WB EXPLODED VIEW ADIN-1010-SBH DROP IN EXPLODED VIEW WIRING DIAGRAM SBH-2-P AND SBH-2-WB WIRING DIAGRAM SBH-2-PWB WIRING DIAGRAM SBH-3-P AND SBH-3-WB... -
Page 4: Introduction
Congratulations! You have just purchased one of the finest pieces of equipment on the market today. Be- fore installing or operating your new Piper equipment, you should read through this manual. This manual should be retained for further reference as it contains installation and operating instructions, service tips, part lists and warranty information. -
Page 5: Installation
INSTALLATION ELECTRICAL CONNECTION WARNING!!!! DO NOT USE EXTENSION CORDS (VOIDS WARRANTY) Ground: The electrical outlet must be provided with an efficient ground, and the voltage and the frequency of the electrical line matches those indicated on the data plate. If unsure about the efficiency of the ground, have your electrical circuit checked by a qualified technician. -
Page 6: Maintenance
Do not use any chlorinated or highly caustic cleaners, acids, ammonia or other corrosive cleaners. These may cause corrosion and/or damage to the stainless steel. Piper only approves soap and water for cleaning stainless steel. Do not allow water to stand in wells for long periods of time. -
Page 7: Silo Removal And Adjustment
SILO REMOVAL AND ADJUSTMENT Each self-leveling unit has internal springs that are field-adjustable without the use of tools. Remove the lids and lift out the self-leveling dispenser through the top to expose springs. Adjust springs equally on each side following the diagram below. Adjustment is set at the factory for most stainless steel wax base plates. -
Page 8: Troubleshooting Guide
Power on / No heat Defective thermostat Replace thermostat Defective heater Replace heater element Check power Switch off - Turn on Blowers not operating Blower faulty Replace blower Loose wiring Check wiring Call Piper Products directly at 800-544-3057 if you need further assistance. - Page 12 ADIN-1010-SBH DROP-IN PARTS BREAKDOWN ITEM NO. PART NUMBER DESCRIPTION 13-700535 SPRING - ATH 12-400183-000 TRAY CARRIER *Wax base dispensers get 16 springs, plate dispensers get 15...
-
Page 13: Wiring Diagram Sbh-2-P And Sbh-2-Wb
WIRING DIAGRAM SBH-2-P AND SBH-2-WB... -
Page 14: Wiring Diagram Sbh-2-Pwb
WIRING DIAGRAM SBH-2-PWB... -
Page 15: Wiring Diagram Sbh-3-P And Sbh-3-Wb
WIRING DIAGRAM SBH-3-P AND SBH-3-WB... - Page 16 Piper Products Service Department shall be final. Any defective parts to be repaired or replaced must be returned to Piper Products, Inc., 300 South 84th Avenue, Wausau, WI 54401, transportation charges prepaid, and they must be properly packed and tagged.
- Page 17 Piper Products, Inc 300 South 84th Avenue Wausau, WI 54401 Phone: 715-842-2724 . FAX: 715-842-3125...