Fujitsu CFD5GRUDB3 Installation Manual page 66

Optical Connector Cleaning
End Surface Cleaning In LC
C.2
End Surface Cleaning In LC
This procedure describes how to clean the end surface in the LC.
Prerequisite:
■ Stick-type cleaner
Caution: Do not touch surface after cleaning. Scars form easily on
the connector's surface.
Caution: Do not use a cleaner except to clean the ferrule.
Step 1
Remove the connector protection cap.
Step 2
Insert the point of the cleaner straight into the ferrule side of the connector.
Note: It is not necessary to come in contact with the connector edges.
Step 3
Circle the ferrule seven times with the cleaner.
Step 4
After cleaning, promptly install in the connector or replace protection cap to protect from dust or debris.
✓
This task is complete.
Additional Instructions:
■ Clean again if the connector end surface is touched after the cleaning.
■ Do not use the same stick-type cleaner more than once.
■ Do not use a cleaner except to clean the ferrule.
·
Issue 1.1, May 2021
Release 1.0
Attention: Ne touchez pas la surface après le nettoyage. Les
cicatrices se forment facilement sur la surface du connecteur.
Attention: N'utilisez pas de nettoyant sauf pour nettoyer la virole.
177
Fujitsu and Fujitsu Customer Use Only