Table of Contents
Advertisement
Light brightness (L):
• 9L is the brightest setting while 1L is
the dimmest one.
To set the light behaviour or brightness:
1. Tap and hold the Light key for 3
seconds to enter the light setting
menu.
2. Light behaviour A appears. Tap the
Light key again to go to the light
brightness L.
3. Tap the temperature regulators
repeatedly to set the desired light
behaviour or brightness.
5.6 Cellaring
In this mode, the appliance switches to
the preset default temperature of 12°C.
To activate the Cellaring mode, tap the
Cellar Mode key. CE on the display starts
blinking. Wait 5 seconds. The mode is
active when CE stops blinking and is lit
at half brightness.
To deactivate the Cellaring mode, tap
Cellar Mode once again.
5.7 Child Lock mode
Activate the Child Lock mode to lock the
keys from an unintentional operation.
To activate the Child Lock, tap and hold
the Cellar Mode key for 3 seconds.
When the mode is on, the lock indicator
lights up at full brightness. After 3
seconds, the lock indicator dims to half
brightness.
If you press any key other
than Cellar Mode, the lock
indicator blinks three times.
To deactivate the Child Lock mode, tap
the corresponding key again.
The Child Lock mode
deactivates after electricity
interruption or unplugging
the appliance.
5.8 Reset air filter
To reset the air filter alarm:
1. Change the carbon air filter. Refer to
the "Replacing air filter" section.
2. Tap and hold the Temperature
increase and Light keys
simultaneously for 5 seconds.
3. The filter indicator turns off for the
next 6 months.
After 6 months, the display
shows the filter indicator to
remind you to replace filter.
5.9 Mute or unmute sounds
The sounds are enabled by default.
To mute or unmute the sounds:
1. Tap and hold the Cellar Mode and
Temperature increase keys
simultaneously for 5 seconds.
2. The display shows Of for 2 seconds
when the sounds are muted, or On
for 2 seconds when the sounds are
unmuted.
5.10 Changing temperature
units
To switch the temperature units between
°C and °F:
1. Tap simultaneously the Cellar Mode
and Temperature decrease keys.
2. Once you set your preferable unit, °C
or °F blinks on the display for 5
seconds.
5.11 Demo mode
Activate the Demo mode to demonstrate
the appliance's features.
To activate the Demo mode, tap and
hold the Light and Cellar Mode keys
simultaneously for 10 seconds.
Once the mode is on, the display shows
dE and On blinking alternately for 5
seconds.
The above message is displayed every 5
minutes to remind you that the appliance
is in the Demo mode.
To deactivate the Demo mode, repeat
the above procedure.
Once you deactivate the mode, the
display shows dE and Of blinking
alternately for 5 seconds.
ENGLISH
11
Advertisement
Table of Contents
