HP ESG-D Series User Manual page 626

Ref Osc Fine
Remote Language
Remove Options 1EH,UN3,UN4,HO3
Hardkey and Softkey Reference
Utility
This softkey is provided for adjusting the internal reference oscillator. This
adjustment is for use by service personnel only. Refer to the calibration guide for
more information.
Softkey Location: Press
Reference Oscillator Adjustment
Pressing this softkey reveals a menu of choices for immediately changing the
signal generator's remote language. You can choose between SCPI, which is the
language chosen for the signal generator for remote implementation of all
features, HP 8648-compatible, and four versions of HP 8656/57-compatible
languages. The HP 8648- and 8656/67-compatible languages are provided for
remote implementation of some features so that this signal generator can be
compatible with systems that use those instruments. Refer to the programming
guide for specifics on which commands are implemented.
Softkey Location: Press
Status after Normal Preset: SCPI
SCPI Commands:
:SYSTem:LANGuage?
If you want to remove the baseband generator (Options 1EH, UN3, UN4, or
HO3), press this softkey once you have removed the hardware from your signal
generator. Then press the
reboot and the hardkey menus will be deleted. If you do not want to remove
Mode
the baseband generator, press
If you have accidently pressed
baseband generator, press the appropriate install option softkey in this same menu
and then press
Confirm Change
If your signal generator was shipped from the factory without Option 1EH, UN3,
UN4, or HO3 installed, and you have not installed any of these options, this
softkey is inactive.
Softkey Location: Press
Remove Options 1EH,UN3,UN4,HO3
5-490
,
Utility Instrument Adjustments
,
Ref Osc Fine
, ,
Utility HP-IB/RS-232 Remote Language
softkey. The signal generator will
Confirm Change
to cancel this operation.
Return
and do not want to remove the
Confirm Change
.
,
Utility Instrument Adjustments
,
,
Install/Remove Options
,