Table of Contents
Advertisement
2) TEST & VISUAL INSPECTION
ALL these verifications must be done on ALL products coming back
in a LEVEL 2 after sales repair centre .
a)
Check the aspect of the rear casing and the antenna
b)
Humidity sticker : a humidity sticker is present on some
BE1 terminals on the shielding that can be seen on the rear
casing side, without openning the handset . Check the state of
the sticker as shown below :
Sticker of a good terminal
c)
Check J904 , the charge connector (corrosion ,contacts)
d)
Check the SIM latch right functioning
e)
Insert a SIM card and check the holding of the SIM latch
f)
Plug a good battery and switch on the handset : check the
charging icon animation on the display, check the holding of
the product on the desk top charger.
ED
All rights reserved.Passing on and copying of this document, use and communication of its contents are not permitted without
authorization
04
09/10/00 REPAIR DOCUMENTATION BE1 and BE3 Level 2
Sticker of a terminal dived in water
This terminal is out of the warranty
BE 1/BE3
4/46
Advertisement
Table of Contents
