Advertisement
Quick-Start Guide
1. Steering Wheel: Controls left / right motion (note that
the wheel can be re-positioned and / or configured for
left-hand use (see full online manual for details).
2. Throttle Trigger: Controls forward / reverse / brake
motion (designed to be operated with index finger).
3. Hand Grip: For holding the transmitter.
4. Antenna: Transmits signal to the receiver located in the
vehicle. Flip up when the transmitter is in use. Fold for
storage.
Battery Installation
4 x AA size alkaline batteries are
the standard configuration and
recommended for ease of use
when getting started. Upgrading
to a rechargeable battery pack
can be carried out at any time.
1. Remove the battery cover
from the transmitter.
2. Insert four new AA batteries
according to the polarity
markings on the battery holder.
3. Reinstall the battery cover.
WARNING: DO NOT ATTEMPT TO CHARGE NON-RECHARGEABLE
BATTERIES, YOU MAY CAUSE AN EXPLOSION.
www.ikonnik-rc.com
5. Power switch: Turns the transmitter ON / OFF.
6. Multifunction Red Indicator LED.
a. Power indicator.
b. Low battery voltage warning. When flashing batteries
should be replaced / recharged before continued use.
7. REV / Pair:
a. Use to reverse servo / channel operation.
b. Use to put the transmitter into pairing mode.
8. Digital Trim: All switches are digital so there's no need
to readjust the trim position for different models after
initial setup.
a. Steering: Controls the hands-off left / right direction
of the vehicle.
b. Throttle: Adjusts the motor speed to STOP when the
trigger is in the hands-off (neutral) position.
9. Dual Rate Adjustment / Memory Reset: Adjusts total
travel of servo in both directions.
10. Battery compartment: Houses [4] AA batteries or a NiMH
rechargeable battery pack for powering the transmitter.
11. Channel 4 / Fail-safe: Toggle Channel 4 ON / OFF. Use to
set the fail-safe in case of signal loss.
12. Mode Switch:
a. Standard Mode: All functions are fully operational.
b. Feature Lock: Disables all buttons except steering
trim.
c. Beginner Mode: Reduces throttle output to 50%.
13. Channel 3 adjustment knob.
14. LED Light ON / OFF: Use to switch the LED Light ON /
OFF.
15. Roller button: Use to scroll through programming options
and select an item.
16. Back button: Use to backtrack through the programming
menus.
17. LCD
Receiver Installation & Connection
Installation
To achieve full operating range with your radio system it
is critical that the receiver antenna be undamaged and
installed properly. It should be installed with as much of
the antenna as possible in a vertical position. The end of
the antenna should be contained inside an antenna tube.
When installing:
• Ensure there are no kinks in the antenna or antenna
tube.
• Never fold the end of the antenna over the tube, this
will reduce the operating range of the system and
damage the antenna.
• Ensure the receiver is mounted securely or padded
against hard impacts.
Advertisement
