Bypass Card Jumpers
|
|
The mode in which the bypass card operates is set by two jumpers. One jumper has links
|
between neighboring pins across its width; the other jumper has links between neighboring
|
pins along its length. The default setting is for Bypass mode. The mode can be changed
|
by swapping the positions of the jumpers. For instructions on how to remove a bypass
|
card and change its mode, see "Signal Cards and Bypass Cards" on page 3-43.
|
Jumpers Set for Bypass Mode
1
|
|
|
|
2
|
|
|
|
1-40
7133 Service Guide
SSA connectors
Backplane connectors
J3
3
Jumpers
4
Bypass circuits
J4