Table of Contents
Advertisement
4
Remove the two nuts 4 and their lock washers.
5
Remove the remote-power-on control unit 5 from the bracket.
6
Replace parts in the reverse order.
Note: If the 7133 remained operational while you removed the remote-power-on
control unit, ensure that the power switch of the remote-power-on control unit that
you are going to install is set to | (on) before you reinstall any power-control cables.
Otherwise, when you install the cables, the internal dc power of the 7133 might turn
off.
Chapter 3. Removal and Replacement Procedures
3-57
Advertisement
Table of Contents
