Table of Contents
Advertisement
Service Inspection Guide
This inspection guide helps you to identify possible unsafe conditions on the 7133. Each
7133 has the necessary safety items installed to protect users and service personnel from
injury. This guide addresses only those items. You should use your good judgment,
however, to identify possible safety hazards that are not covered by this guide.
If any unsafe conditions are present, you must determine how serious the possible hazard
could be, and whether you should continue without first correcting the problem.
Consider the following conditions and the safety hazards they present:
Electrical hazards (especially primary power): Primary voltage on the frame can
cause serious or lethal electrical shock.
Explosive hazards: A bulging capacitor can cause serious injury.
Mechanical hazards: Loose or missing items (for example, nuts and screws) can
cause serious injury.
Using the following inspection checklist as a guide, inspect the 7133 for unsafe conditions.
See, if necessary, any suitable safety publications.
Inspection Checklist
1. Remove all power from the 7133 (see "All Power" on page 3-7).
2. Check the frame for damage (loose, broken, or sharp edges).
3. Check the power cable and ensure that:
a. The third-wire ground connector is in good condition. Use a meter to check that
the third-wire ground continuity is 0.1 ohm or less between the external ground pin
and the frame ground.
b. The insulation is not worn or damaged.
4. Check for any obvious nonstandard changes. Use good judgment about the safety of
any such changes.
5. Check inside the 7133 for any obvious unsafe conditions, such as metal particles,
water or other fluids, or marks of overheating, fire, or smoke damage.
6. Check for worn, damaged, or pinched cables.
7. Ensure that the voltage specified on the product-information label matches the
specified voltage of the electrical power outlet. If necessary, verify the voltage.
8. Inspect the fan-and-power-supply assembly and check that the fasteners in the cover
of the power-supply unit (screws or rivets) have not been removed or disturbed.
9. Before connecting the 7133 to the using system, check the grounding as described in
"Checking the Grounding of the 7133" on page 1-62.
Chapter 1. Reference Information
1-61
Advertisement
Table of Contents
