Table of Contents
Advertisement
SCANNER
Scan a 1D barcode
1) Open ReaderConfig and tap Scan Test on the menu bar.
2) Aim the scanning window at the barcode to read. Move the device, having the barcode
located in the center of the scanning area.
3) Press any of the two side triggers. The scanning light beams to read the printed barcodes.
The buzzer beeps after scanning. The scanning light goes off once the data is decoded,
or when the decode timeout period has passed.
Scan a 2D barcode
1) Open ReaderConfig and tap Scan Test on the menu bar.
2) Aim the scanning window at the barcode to read. Move the device, having the barcode
located in the center of the scanning area.
3) Press any of the two side triggers. The scanning light beams to read the printed barcodes.
The buzzer beeps after scanning. The scanning light goes off once the data is decoded,
or when the decode timeout period has passed. USA and Canada e-label
CONNECTION
Via Bluetooth or WLAN
Connection may fail when the mobile POS is around other wireless machines or power
cables as the radio frequencies of those may cause interferences.
If communication fails, move the devices much closer to each other, and try to communicate
again
After turning on, Bluetooth power is sustained even when the mobile POS is suspended.
However, if the power mode is switched to Airplane Mode, Bluetooth power will be turned off
regardless of the settings.
To a charging cradle
Do not insert the mobile POS to a charging cradle if water or drippings are staying on the
device.
The LED indicator on a charging cradle shows the status of battery charging only; the status
of terminal charging is shown on the device itself.
Not Charging could be the result of battery damage, battery's failure to touch the connector
or AC plug coming off.
Charging error could be due to high battery temperature.
- 11 -
Important Notices
Advertisement
Table of Contents
