Page 1
TCH601 60cm Ceramic Hob Black Instruction manual...
Page 2
CONTENT 1……………………………………….Notice 2………………………………………. Installation 3………………………………………..Description of the Ceramic hob surface layout 4………………………………………..Using the ceramic hob 5………………………………………..Hob guidelines 6…………………………………………Maintenance and cleaning 7…………………………………………Environmental note...
Page 3
1.Notice Caution! Do not use the ceramic hob until you have read this instruction manual. The ceramic hob is intended for household use only. The appliance becomes hot during operation. Take care not to touch the hot surface. ...
Page 4
If it is necessary for younger family members to be in the kitchen, please ensure that they are kept under close supervision at all times. General Safety Children less than 8 years of age shall be kept away unless continuously supervised.
Page 5
Warning: Before obtaining access to terminals, all supply circuits must be disconnected. WARNING: Use only hob guards designed by the manufacturer of the cooking appliance or indicated by the manufacturer of the appliance in the instructions for use as suitable or hob guards incorporated in the appliance.
Page 6
IMPORTANT: must observe ventilation requirements shown in the drawing opposite. IMPORTANT: There are ventilation holes around the outside of the hob. YOU MUST ensure that these holes are not blocked by the work top, when you put the hob into position (see drawing opposite).
Page 7
should match the connection type and the power rating of the ceramic hob. The connection cable must be secured in a strain-relief clamp. Warning! Remember to connect the safety circuit to the connection box terminal marked with .The electricity supply for the ceramic hob must have a safety switch which enables the power to be cut off in case of emergency.
Page 8
Replacing the mains supply cable If the mains supply cable is damaged, then it must be replaced by an appropriate replacement. The mains supply cable should be replaced in accordance with the following instructions: Switch the appliance off at the control switch.
Page 9
Control panel layout 1. Cooking zone rear left select button 2. Cooking zone front left select button 3. Cooking zone rear right select button 4. Cooking zone front right select button 5. minus button 6. Timer indicator 7. ON/OFF button 8.
Page 10
Each touch control has a visual display that corresponds to it. Switching the hob top on Press the ON/OFF button(7) to switch on the appliance. The hob will beep once and all of the cooking zone indicators will light briefly, then go out. ...
Page 11
temperature of the zone is over 60°C and is therefore still high enough to cause injury. When the temperature of the zone falls below 60°C, then the letter “H” will go out. IMPORTANT: The residual heat indicator will disappear if the mains supply to the product is cut.
Page 12
If the set time exceeds 99 minutes, the timer display will return to showing 0. If you press the plus (9) and minus buttons (5) simultaneously, the timer display will reset to 0. Self-heating mode Your hob can be self-heating following the below steps: ...
Page 13
To cancel a countdown time that is in progress, press the plus and minus buttons simultaneously. IMPORTANT: The countdown timer controls the entire hob, rather than an individual cooking zone. When this function is used, the hob will switch off entering stand-by mode. Safety cut-off ...
Page 14
When cold, the bottom of the pans should be slightly concave, as they expand when hot and lie flat on the surface of the hob. This will allow the heat to transfer more easily. The best thickness for the bottom of the pans is 2 – 3 mm of enamelled steel and 4 –...
Page 15
You may find it easier to clean some deposits whilst the hob surface is still warm. However you should take care not to burn yourself if cleaning the hob surface when it is still warm. After each use Wipe the appliance over with a damp cloth. ...
Page 16
engineer is concerned that damage will be caused to the appliance or your kitchen, then he will not complete a repair. 7. Environmental note Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut the cable off directly behind the appliance to prevent misuse.
Need help?
Do you have a question about the TCH601 and is the answer not in the manual?
Questions and answers
Is this hob got to be hard wired in by an electrician