Download Print this page
Oki 42872901 Installation Manual
Oki 42872901 Installation Manual

Oki 42872901 Installation Manual

Puncher-unit

Advertisement

Quick Links

Puncher-Unit
Technician's Installation Guide
1. Unpack the Puncher-Unit and check the
contents:
[1]
Puncher-Unit
[2]
Safety Labels
[3]
Screw (for securing hole punch unit to finisher:
see stop 14)
Orange Cable (4 leads)
[4]
[5]
Purple Cable (5 leads)
(P/N 42872901,42872903,42872904)
2.
Remove the packing tape, blue spacers and
any other packing materials from the Puncher
-Unit.
3. Turn off the printer.
4. On the back of the finisher/inverter unit,
unplug the inverter power cord (1) and the
connecting cord (2) to the finisher.

Advertisement

loading

Summary of Contents for Oki 42872901

  • Page 1 Puncher-Unit (P/N 42872901,42872903,42872904) Technician’s Installation Guide 1. Unpack the Puncher-Unit and check the Remove the packing tape, blue spacers and contents: any other packing materials from the Puncher -Unit. 3. Turn off the printer. 4. On the back of the finisher/inverter unit, unplug the inverter power cord (1) and the connecting cord (2) to the finisher.
  • Page 2 5. Push in on the finisher release lever and slide 8. Remove the internal cover: the finisher away from the inverter. a. Remove the two screws behind the cover. b. Remove the two screws holding the side of the cover in place. 6.
  • Page 3 9. Remove the screws securing the rear cover 10. Remove the two screws at either end of (two on the left side [a] and one on the right the hole punch blank. side [b]), then remove the rear cover. 11. Swing up the finisher top cover (1) and lift out the punch blank unit (2).
  • Page 4 12. Remove the top of the blank unit: you need 15. Open the finisher top cover and snap the top this to install the Puncher-Unit. Store the bo- of the blank into place on the Puncher-Unit. ttom of the blank in case you ever remove the hole punch from the finisher.
  • Page 5 17. Insert the orange cable (4 leads) into the 20. Plug the orange cable into the connecter on connector on the Puncher-Unit board. the main board. Insert the purple cable (5 leads) into the connector on the Puncher-Unit board. Plug the purple cable into the connector on the main board.
  • Page 6 22. Reinstall the back cover and secure it in 23. Reinstall the internal front cover and secure place: two screws on the left side (a) and it with four screws. one screw on the right side (b).
  • Page 7 24. Push the blue knob back into place. 26. Apply the appropriate language safety label: 27. Slide the finisher back into the inverter. Make sure it locks in place. 25. Close the finisher front cover. 28. Reattach the cable between the finisher and inverter and the finisher power cable.
  • Page 8 With a suitable document open in a software apprication, select [File] [Print]. b. Select the appropriate Oki printer, then click [Properties]. c. Click the [Job Options] tab. d. Under [Finisher], [Output Bin], select [Finisher(Face-up)] or [Finisher(Face-down)] from the drop-down list.

This manual is also suitable for:

4287290342872904