Table of Contents
Advertisement
42
EN
Power Switch
REW
PLAY
IN/OUT
IN
1
0 : 00 : 25
2
3
4
5
6
7
8
COUNTER
TOTAL
IN
0 : 00 : 25
1
0 : 03 : 18
2
3
0 : 02 : 33
0 : 04 : 11
4
5
6
7
8
COUNTER
TOTAL
USING THE REMOTE CONTROL UNIT
Remote sensor
FF
PAUSE
CANCEL
ON/OFF
RM-V700U
(optional)
OUT
- - : - - : - -
0 : 00 : 25
0 : 00 : 00
OUT
0 : 01 : 05
0 : 03 : 31
0 : 02 : 53
- - : - - : - -
0 : 04 : 11
0 : 01 : 13
SELECT SCENES
4
START SOURCE PLAYBACK
Press PLAY, then press ON/OFF on the remote
control. Make sure to point the remote control at the
camcorder's remote sensor.
•The R.A. Edit counter display appears.
5
REGISTER BEGINNING OF SCENE
Press REW or FF to locate the beginning of the scene
you want, then press IN/OUT to register that point.
•The data appears under "IN" on the display.
6
REGISTER END OF SCENE
Press REW or FF to locate the end of the scene and
press IN/OUT to register it.
•The data appears under "OUT" on the display.
•The total time of the registered scene(s) is displayed
at the bottom of the screen.
7
REGISTER ADDITIONAL SCENES
Repeat steps 5 and 6 for each additional scene
(as many as 8).
8
MAKE CORRECTIONS (IF NECESSARY)
Press CANCEL during steps 5 and 6 to erase the most
recently registered point.
NOTES:
There must be at least one second between an in-point
and its corresponding out-point.
To ensure correct operation, there should be at least
15 seconds between an out-point and the next in-point.
Blank portions of a tape cannot be registered as in-points
or out-points.
If it takes more than 5 minutes to search for an in-point,
the VCR's Record-Pause mode is cancelled and editing
does not take place.
Pressing ON/OFF clears all in- and out-points from
memory.
Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.
Turning off the camcorder's power erases all registered
in- and out-points.
(cont.)
Advertisement
Table of Contents
