Sunlight Supply Titan Controls Atlas 4 Instruction Manual

Dual zone co2 controller

Table of Contents

Download this manual

Notes:

_________________________________________________

Atlas 4

_________________________________________________

Dual Zone CO2 Controller

________________________________________________

Instruction Manual

1 Square = 1 Foot

VANCOUVER, W ASHINGTON U.S.A.

www.titancontrols.net

Table of Contents

Need help?

Do you have a question about the Titan Controls Atlas 4 and is the answer not in the manual?

Page 1 Notes: _________________________________________________ ® _________________________________________________ _________________________________________________ Atlas 4 _________________________________________________ _________________________________________________ _________________________________________________ Dual Zone CO2 Controller ________________________________________________ Instruction Manual 1 Square = 1 Foot VANCOUVER, W ASHINGTON U.S.A. VANCOUVER, W ASHINGTON U.S.A. www.titancontrols.net www.titancontrols.net...
Page 2 Step 1: Connecting the Equipment WARRANTY SERVICE: Please read warranty information ﬁ rst If after reviewing the troubleshooting tips the unit will still not work, you should return it to the Place the Controller on a wall in the Dealer where you purchased the controller. They will be able to further evaluate the unit and test its most convenient location.
Page 3 Appendix 2 Step 4: Setting high value Click knob and turn to set high ppm value of Calibration of CO2 sensor selected zone. This is the maximum CO2 level Important Notice : This step is not required for a new unit (factory calibrated).Verify the generator will allow.
Page 4 Step 7: Setting operating mode Click knob and turn to select your Control Mode for each zone. For set –up using two burners F11: CO2 enrichment – day only F12: CO2 enrichment – night only F13: CO2 enrichment – day & night F14: CO2 exhausting –...