Advertisement
For longer life, use alkaline batteries.
Batbot
• Loosen the screw in the battery compartment.
Lift to remove the battery compartment.
• Remove the exhausted batteries and dispose of
them properly.
• Insert six, new AA (LR6) alkaline batteries.
• Replace the battery compartment and tighten
the screw.
• If Batbot begins to operate erratically, you may
need to reset the electronics. Slide the power
switch off and then back on again.
Battery Installation
1,5V x 6
AA (LR6)
1,5V x 2
AAA (LR03)
Remote Control
• Loosen the screw in the battery compartment
door and remove the door.
• Insert two, new AAA (LR03) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
• If the remote control begins to operate erratically,
you may need to reset the electronics. Remove
and reinstall the batteries.
Battery Safety Information
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of non-
use. Always remove exhausted batteries from
the product. Dispose of batteries safely. Do not
dispose of this product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used,
they are only to be charged under
adult supervision.
2
Advertisement
