Table of Contents
Advertisement
Quick Links
OWNER'S MANUAL
monoblock subwoofer amplifier
Thank you for purchasing a JL Audio amplifier for
your automotive sound system.
Your amplifier has been designed and manufactured to exacting
standards in order to ensure years of musical enjoyment in your vehicle.
For maximum performance and extended warranty
coverage, we highly recommend that you have your new amplifier
installed by an authorized JL Audio dealer. Your authorized
dealer has the training, expertise and installation equipment to ensure
optimum performance from this product. Should you
decide to install the amplifier yourself, please take the time
to read this manual thoroughly so as to familiarize yourself
with its installation requirements and setup procedures.
If you have any questions regarding the instructions in this
manual or any aspect of your amplifier's operation, please contact your
authorized JL Audio dealer for assistance. If you need further assistance,
please call the JL Audio Technical Support Department
at (954) 443-1100 during business hours.
Advertisement
Table of Contents
Related Manuals for JL Audio Slash v2 250/1V2
Summary of Contents for JL Audio Slash v2 250/1V2
- Page 1 If you have any questions regarding the instructions in this manual or any aspect of your amplifier’s operation, please contact your authorized JL Audio dealer for assistance. If you need further assistance, please call the JL Audio Technical Support Department...
-
Page 2: Protect Your Hearing
(pg. 8) Amplifier Channel for Bass EQ (pg. 8) (pg. 9) 2 | JL Audio - 250/1 Owner’s Manual PLANNING YOUR INSTALLATION It is important that you take the time to read this manual and that you plan out your installation carefully. -
Page 3: Product Description
Hz. It is not designed for driving midrange negative power wire to it using appropriate speakers or tweeters. Every aspect of its hardware (use of the JL Audio ECS master operation has been optimized for low-frequency ground lug, XB-MGLU is recommended). - Page 4 RCA cables or plugs or use the to mono for the internal amplifier section. JL Audio ECS Speaker Wire to RCA adaptor (XB-CLRAIC2-SW). IMPORTANT The output of the amplifier will decrease for a given input voltage when the “Input Range”...
-
Page 5: Crossover Controls
8 | JL Audio - 250/1 Owner’s Manual 2) Precise Frequency Selection: The filter recommended to protect the speaker(s) from frequency markings on the front panel of excessive excursion below box tuning. - Page 6 JL Audio dealer so top of the amplifier. These are as follows: that it may be sent in to JL Audio for service. There are no user serviceable parts or fuses inside 1) “Power” (Green): lights to indicate that the the amplifier.
- Page 7 If the channel these reasons is ease of setup. Because each pair is operating in stereo, it is only necessary JL Audio amplifier will always deliver the to measure one channel. If bridged, make sure same amount of power within its operational...
-
Page 8: Appendix D: Trouble Shooting
Check the nominal load impedance to verify that the amplifier is driving a load between 1.5 - 4Ω. JL Audio monoblock amplifiers have two “+” positive connections and two “–”... -
Page 9: Installation Notes
INSTALLATION NOTES: Use this diagram to document your amplifier’s switch and control positions. 16 | JL Audio - 250/1 Owner’s Manual... - Page 10 NOTES NOTES 18 | JL Audio - 250/1 Owner’s Manual...
- Page 11 LIMITED WARRANTY - AMPLIFIERS (USA) JL AUDIO warrants this product to be free of defects in materials and workmanship for a period of ninety (90) days from the original date of purchase. The warranty term is extended to two (2) years if installation is performed or approved by an authorized JL AUDIO dealer (proof of installation or approval required on purchase receipt).