Table of Contents
Advertisement
6.. Unhook.the.two.hammer.springs.(23).
7.. Remove.the.connecting.link.nuts.(41).and.links.(40)...
8.. Remove.the.hammer.post.cap.screws.(25),.actuator.link.
screws. (36),. bumper. block. cap. screws. (20),. and. lock.
ring.(19)..Now.you.can.lift.the.sieve.platform.with.main.
shaft.out.of.its.center.housing.(15)...
9.. If.you.remove.the.cam.shaft.hangers.(27).for.any.reason,.
reassemble.exactly.as.removed..The.roller.clutch.block.
(33).and.one.cam.shaft.hanger.(27).contain.overrunning.
clutches. which. must. be. installed. to. allow. correct. rota-
tion.of.the.cam.shaft.(29),.or.serious.damage.will.result.. .
10.. Main. bearings. have. permanent. lubrication. and. are.
sealed.inside.the.main.housing.(15)..This.main.housing.
with. bearings. and. hub. should. not. be. disassembled. in.
the.field;.replace.them.as.a.unit.if.necessary.
5.0 TROUBLESHOOTING
•..Unit Fails to Operate:
Check.motor,.electrical.connections,.and.timer..Replace.or.
reconnect.as.necessary..Check.drive.belt.tension;.replace.
belt.if.worn.
•..Unit Runs, but Fails to Give Impact Tapping:
Remove. covers,. drive. belt,. and. mounting. cap. screws. (16)..
Replace.or.reconnect.hammer.springs.(23).as.required.
•..Unit Operates but is Excessively Noisy:
Disassemble.through.step.4.in.Section.4.2..Check.resilient.
faces.on.bumper.block.(20).and.replace.block.if.necessary.
•..Unit is Unstable; Shakes or Walks Too Much:
a.. Readjust. level. using. the. leveling. legs,. and. lock. with. lock.
nuts...
b.. For. SS-12R,. be. sure. that. weighted. platform. adapter. is.
used.when.using.8in.test.sieves.
c.. Loosen.and.re-clamp.the.sieve.stack.
d.. Check.sieve.stack.height..If.over.20in,.see.Section.3.0.
Gilson Tapping Sieve Shaker Manual
6.0 TECHNICAL SUPPORT
Contact.Gilson.Technical.Support.for.assistance.with.applica-
tions,.operation,.maintenance,.or.repair.
•.
Telephone: 800-444-1508
•.
Email: techsupport@gilsonco.com
•.
Web:.globalgilson.com
5
Advertisement
Table of Contents
