Advertisement
ETC Installation Guide
P-TS7-E Touchscreen
Install the Touchscreen
The touchscreen bracket is designed for two positions, service and operation. When installed so
that the pins are in the first slots on the bracket the touchscreen is held out at the bottom for
service.
1. Install the RJ11 control cable provided in the installation kit to the RJ11 jack on the
termination board and to the receptacle on the touchscreen.
2. Install the Ethernet RJ45 patch cable provided in the installation kit to the RJ45 jack on the
termination board and to the receptacle on the touchscreen.
3. Hold the touchscreen at a slight angle, insert the top of the unit into the collar and hook the
bracket onto the pins on each side of the collar.
4. To move the touchscreen from the service position to the operation position, lift to unhook
the pins and rotate the bottom inward until the touchscreen face is vertical.
5. Apply firm pressure simultaneously to the center of the left and right edges of the
touchscreen, pushing the unit inward until it audibly snaps onto the collar. When properly
installed, the touchscreen should not easily unsnap from the collar.
6. To remove the touchscreen, gently insert a flat blade screwdriver into the pry slot (indicated
in the image below) and unsnap the touchscreen from the collar. Then lift the bottom
upward slightly and rotate outward.
Indicators
When the touchscreen powers up, LEDs on the bottom of the touchscreen illuminate according to
the power and data activity, the unit will briefly display a startup screen, and will automatically
load a configuration if one is present. For more information about using the service panel or saving
or loading a configuration, see the Paradigm P-TS7 User Manual .
Pry Slot
P-TS7-E Touchscreen
Note:
The RJ11 connection provides ground connection to the back box
and must always be installed.
USB Port
SD Port
STATUS
Service Position
Operation Position
Pry Slot
NET
Page 4 of 4
ETC
Advertisement
