Advertisement
Removing Collected Water
(continued)
NOTE:
1. Screw the hose onto the drainage connector of the unit directly or through the drainage adapter, continuous drainage option
will automatically start.
2. Check the seal between the hose and the drainage adapter. If there is a small leak then replace the hose gasket and re-tighten
the hose.
3. It is recommended that a Dehumidifier Drain Hose - 11/16" (17.5 mm) or larger be used.
4. When applying continuous drainage option, place dehumidifier on a horizontal surface and make sure garden hose is clear
of any obstructions and directed downward. Improper installation or use of hose may result in water filling up the bucket
and causing the unit to shut off. Empty water bucket if shut-off occurs, then check dehumidifier location and hose for
proper installation.(fig.10)
5. To quit continuous drainage option and collect water using the bucket, you need to remove the garden hose and take out
draingage joint to avoid leakage, then put the drain cover back.
6. If bucket fills after a long period of continuous use, remove and check hose for blockage by dirt.
Care and Cleaning
1. Filter
a. Remove the filter every two weeks based on normal operating conditions.
b.
To remove the filter, pull the tabs and then take out the filter.
c.
Wash the filter with clean water then dry. Do not dry the air filter with
electric hair dryer.
d.
Once filter is dry, replace on rear of unit and snap in place.
2. Cabinet
a. Dust cabinet with an oil-free cloth, or using a damp cloth.
b. Vacuum grill using brush attachment.
3. Water Bucket
a. Clean bucket with warm water and detergent.
Storage
When unit is not in use, unplug and tidy up the cord as shown below.
Care and Cleaning & Storage
fig. 10
Tabs
Air Filter
9
Advertisement
