Table of Contents
Advertisement
Menu Operation
Basic TV operation
TURN ON LCD TV
1.Connect power cable to mains supply and turn on the power by using the " Switch" at the back of
the TV on the right hand side. The standby indicator on the front of the TV will light up in red.
2.Use the POWER button
the indicator will turn green.
TURN OFF LCD TV
Press the POWER button on the front of the TV or
into standby mode,
NOTE: When you initially use the TV, you will see the "First Time Installation" menu as below:
Please make sure the TV aerial is plugged
into the RF socket at the rear of the TV.
Press the "OK" button on the remote control to
start the tuning procedure. This process will find
all available ATV and DTV channels and store
them.
By pressing the "Quick start" button, the first time
installation can be recalled at any time.
1. Press VOL+/- to adjust the volume.
2. If you want to switch the sound OFF, press the MUTE
3. You can cancel this function by pressing MUTE or VOL+ button.
1. Using the CH+/- on the front panel or PROG+/- on the remote control.
Press CH+/PROG+ to increase channel number.
Press CH-/PROG- to decrease channel number.
TV (ATV only)
2.
Press -/-- button, then the screen will display "-", press again it will become "- -".
When it displays "-", you should then press a unmber of 0-9 to play the channel you desired;
When it displays "- -", you should then press two unmbers to play the channel you desired.
3. DTV using only 0-9 to select channel for example: Channel 83 press buttons 8 and 3
on the front of the TV or STANDBY
h t
e
s
a t
n
d
b
y
n i
d
c i
t a
r o
First time installation
Using 0-9 digital buttons and -/-- button
STANDBY
w
l l i
u t
n r
e r
. d
Please make sure the TV aerial is plugged
into the RF socket at the rear of the TV.
NOW PRESS OK
7
button
o
n
h t
e
h
a
n
d
s
button
on the handset to turn the TV off
First Time Installation
t e
o t
u t
n r
o
n
h t
e
T
V
,
Advertisement
Table of Contents
