Menu Operation - Marks & Spencer MS1975F User Manual

Menu Operation

Basic TV operation
TURN ON LCD TV
1.Connect power cable to mains supply and turn on the power by using the " Switch" at the back of
the TV on the right hand side. The standby indicator on the front of the TV will light up in red.
2. Press the POWER button on the top of the TV or the STANDBY button on the remote control to
turn on the TV, the indicator will light green.
TURN OFF LCD TV
Press the POWER button on the top of the TV or the STANDBY button on the remote control to turn
the TV off into standby mode, the indicator will light red.
NOTE: When you initially use the TV, you will see the "First Time Installation" menu as below:
Please make sure the TV aerial is plugged
into the RF socket at the rear of the TV.
Press the "OK" button on the remote control to
start the tuning procedure. This process will find
all available ATV and DTV channels and store
them.
By pressing the "Quick start" button, the first time
installation can be recalled at any time.
1. Press VOL+/- to adjust the volume.
2. If you want to switch the sound OFF, press the MUTE
3. You can cancel this function by pressing MUTE or VOL+ button.
1. Using the CH+/- on the front panel or PROG+/- on the remote control.
Press CH+/PROG+ to increase channel number
Press CH-/PROG- to decrease channel number.
2. TV (ATV only) Using 0-9 digital buttons and -/-- button
Press -/-- button, then the screen will display "-", press again it will become "- -".
When it displays "_" press a number from 0 – 9 to activate the chosen channel.
When it displays "_ _" press two numbers: for example 2 and 3 to activate channel 23.
3. DTV using only 0-9 to select channel for example: Channel 83 press buttons 8 and 3
9
First time installation
Please make sure the TV aerial is plugged
into the RF socket at the rear of the TV.
First Time Installation
NOW PRESS OK