Table of Contents
Advertisement
English
Do not charge or leave the internal lithium battery in a hot place such as
near a fire or on a heater because it could overheat and ignite.
When you dispose of the internal lithium battery, insulate it by wrapping
the terminals with tape. Mixing the battery with other metals or batteries
may lead to fire, heat, or explosion.
Be sure your power cord meets the relevant safety standards and
includes a power system ground terminal (PE terminal).
Handle the power cord with care. Improper handling may lead to fire or
shock.
Do not modify or attempt to repair the cord.
Do not place any object on top of the cord.
Avoid excessive bending, twisting, and pulling of the cord.
Do not place the cord near heating equipment.
Check that the plug is clean before plugging it in.
Be sure to push the prongs all the way in.
Do not use a damaged cord.
Regularly remove the power plug from the outlet and clean the base of
the prongs and between the prongs. If you leave the power plug in the
outlet for a long time, dust may collect on the base of the prongs, causing
a short and fire.
CAUTION:
When replacing the battery, use only an equivalent type battery
recommended by the manufacturer. If your system has a module
containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not connect cables other than those specified in this manual. Doing
so may result in fire or improper operation.
Do not connect the unit to electrical outlets that are close to devices
that generate voltage fluctuations or electrical noise. In particular, stay
clear of devices that use large electric motors.
Always connect the power cable to the IR-320 before plugging it into the
wall outlet.
Be sure to push the plug of the power cord all the way into the AC inlet of
this product. The plug should make contact with the back of the inlet.
When disconnecting the power cable, hold the plug firmly. Do not tug
on the cord itself.
Be sure to set this product on a firm, stable, horizontal surface. The
product may break or cause injury if it falls.
4 IR-320 User's Manual
Advertisement
Table of Contents
