Fold in ASO"1" to nest onto housing rib structure as shown below (for ASO version only).
12.
Assy"5" to Housing (keep ASO Red, Brown and Grey wires at the right side of the Swivel saddle)
Assemble
Inlay
13.
Fasten T1 Screw with Screw driver (T15) to Inlay Assy then paste the Inlay Sticker over T1 screw area, close the
14.
Filling Door.
Assemble Tank Seal.
15.
Dress ASO"1" Grey wire follow by Red wire as shown below (for ASO version only).
16.
Connect ASO"1" &
17.
(for ASO version only)
Dress Brown wire on Housing rib as shown below (for ASO version only).
18.
Published by Philips Consumer Lifestyle
Document No. : CSW-07-081-18052
Cord"6" brown wire through the Lamp Assy Connection Loop as shown below.
Mains
Page 14 of 25
For internal use only