Advertisement
6. Connect Lamp Assy to Frame Connectors as shown below.
Note: When Silicone Sleeve are used, make sure it is in correct position covering exposed wire.
Cord"6" Brown wire in between Lamp Assy wires as shown below (for ASO version only).
7. Shift
Mains
8. Assemble Thermostat Bush to
Assy"7" on top of
9.
Place
Water Tank
Fasten A3 Screw with Screw driver (Philips Cross Head recess no. 2) between Housing & Cover.
10.
Reassemble Spring to Bullet before mount it back to Tank Top as shown in blue circle below.
Assemble Thermostat Dial.
11.
Published by Philips Consumer Lifestyle
Document No. : CSW-07-081-18052
Cover and Soleplate Mtd
Cover and Soleplate Mtd
Assy"4".
Assy"4".
Page 13 of 25
For internal use only
Hide quick links:
Advertisement
