Philips AZUR PERFORMER GC 4532 Service Manual page 15

Fold in Lamp Assy and nest Neon Lamp inside pocket as shown below. Dress wires, ensuring the Silicone Sleeves
19.
(where applicable) are held in place between Lamp and dressing rib.
Fasten A2 Screw with Screw driver (Philips Cross Head recess no.2) from Clamping Plate to Housing.
20.
Notes: Mains Cord"6" with ~ 8mm distance from Clamping Plate edge to Mains Cord tape as shown above.
Dress Mains Cord"6" up to the Swivel Saddle.
21.
Assemble Deco Plate to Tank Top.
22.
Assemble Backplate
23.
Fasten A1 Screw with Screw driver (Philips Cross Head recess no. 2) to
24.
Cautions:
a. before fastening screw, relocate the screw with first thread. Once done fasten the screw.
b. Do not drop, hit or knock the ASO (for ASO version only).
c. Ensure there is click sound after Connector to Terminal engage. Refer to wiring diagram for detail.
d. Take note of live part (red & blue wire) must apply with Heat Sink Paste after wire dressing on area as shown.
Notes: Heat Sink Paste – Dow Corning 340 Heat Sink Compound to be used.
Published by Philips Consumer Lifestyle
Document No. : CSW-07-081-18052
2K"2".
Backplate
Page 15 of 25
2K"2".
For internal use only