Philips AZUR PERFORMER GC 4532 Service Manual page 12

Reassembly Instruction
1. Assemble the Calc Collector
2. Assemble Swivel to
Cord"6" (connectors side) to Swivel.
3. Insert Mains
Cord"6" N & E wires to designated Frame Conncetors as shown below.
4. Connect Mains
Cautions: - Due to high wattage of the iron, only specified Mains Cord must be used.
- Should there be any damage observed on the Mains Cord, it must be replaced.
- To replace Mains Cord once it is disassembled in the course of repair.
5. Connect ASO"1" Red and Grey wires to designated Frame Connectors as shown below (for ASO version only).
Published by Philips Consumer Lifestyle
Document No. : CSW-07-081-18052
Assy"3" to Cover.
Backplate 2K"2".
Page 12 of 25 For internal use only