Huawei VP9650 Product Description page 18

HUAWEI VP9650
Product Description
Figure 3-9 HCCA board front panel
1 FE port
NOTE
4 ACT indicator
7 RST button
l The IP addresses of the FE, GE0, and GE1 ports must be in different network segments.
l GE0 port IP addresses of all boards must be in the same network segment. GE1 port IP
l
Table 3-5 Button and ports in the board front panel
Component
FE maintenance port
GE0 port
GE1 port
Issue 06 (2018-08-10)
l FE is the abbreviation
for fast Ethernet. The
transmission rate on an
FE port is 100 Mbit/s.
CAUTION
Otherwise, network errors will occur.
addresses of all boards must be also in the same network segment.
Ports
The HCCA board front panel provides one button and ports, as shown in
Table 3-5 lists the button and ports.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 GE1 port
NOTE
GE is the abbreviation for
gigabit Ethernet. The
transmission rate on a GE port
is 1000 Mbit/s.
5 RUN indicator
8 GE0 port
Description
l This port is used for internal debugging. The IP addresses
of the FE port and the GE0 or GE1 port must be in different
network segments.
l If you fail to use the GE0 port to log in to the MCU
command-line interface (CLI), use the FE port.
This is a service network port used for signaling and media
stream communications.
The GE0 and GE1 ports are backups for each other. If a
network cable is removed from either of the ports, the MCU
automatically switches the service to the other port.
3 Product Structure
3 Optical ports: SFP1 (upper)
and SFP0 (lower)
6 ALM indicator
9 RS-232 serial port
Figure 3-9.
15