Table of Contents
Advertisement
Make your home luxury.
STEP 7: CONNECT WATERLINES
Connect waterlines(15&16) to hot and cold copper lines. Connect
waterlines to angle stops.
Apply pipe tape to avoid leakage. Tighten both ends of waterlines
with a wrench un�l snug. Turn on hot and cold angle stops and
check for leaks.
STEP 9: CHECK FOR LEAKS
Check for leaks at the connec�ons. Re�ghten if necessary.
STEP 6: ATTACH SPRAY HOSE AND COUNTERWEIGHT
Connect spray hose and install weight on lowest ver�cal point on spray hose.
Note:
a Connect the quick coupling: Press the bu�on and insert connector to the end
with force and hear a click.
b Remove the quick coupling: Press the bu�on and pull out the connector with
force.
c Install weight: Push the bu�on and open the weight, clamp the spray
hose(black) white point in the middle groove, the height of the weight from
bo�om should be more than 5".
STEP 8: FLUSH SPRAY HOSE
Remove spray head(6) from spray hose. Hold �p of spray hose.
Turn faucet on and let the water run for 60 seconds to flush any
debris.
CARE & MAINTENANCE：
*To keep the product clean & shining, follow the steps below:
1.Rinse with clean water & dry with a so� cloth
2.Do not clean with soaps, acid polish, abrasives, or harsh cleaners
3.Do not use cloth with a coarse surface
4.Unscrew the aerator and clean when necessary
5
Advertisement
Table of Contents
