Inserting Cable Head; Fastening Cable Head - Hitachi H8S/2212 Series User Manual

2.2.3

Inserting Cable Head

Check the location of pin 1 before inserting.
Align pin 1 on the IC socket for a FP-64E package on the user system with pin 1 on the user system
interface cable head, and insert the user system interface cable head into the IC socket on the user
system, as shown in figure 3.
2.2.4

Fastening Cable Head

1. Use a screwdriver whose head matches the screw head.
2. The tightening torque must be 0.13 N•m or less.
If the applied torque cannot be accurately measured,
stop tightening when the force required to turn the screw
becomes significantly greater than that needed when first
tightening. If a screw is tightened too much, the screw
head may break or an IC socket contact error may be
caused by a crack in the IC socket solder.
3. If the emulator does not operate correctly, cracks might
have occurred in the solder. Check conduction with
a tester and re-solder the IC socket if necessary.
Fasten the user system interface cable head to the IC socket for a FP-64E package on the user system
with the four screws (M2
tightened a little at a time, alternating between screws on opposing corners. Take special care, such
as manually securing the IC socket soldered area, to prevent the soldered IC socket from being
damaged by overtightening the screws or twisting the components.
6
CAUTION
CAUTION
x 12 mm; with four flat washers) provided. Each screw should be