BRC Mesa Standard Wall Mount Electric HA Table Installation Manual

| Mesa Standard Wall Mount Electric HA Table
This guide assumes that the wall mounting surface is level and plumb. Mounting into wood wall studs or concrete is recommended. For metal wall studs or otherwise,
sufficient support must be added to accommodate heavy loads. Contact your BRC representative for weight limit requirements and recommendations.
Preparing The Wall Panel
Prepare the wall panel by connecting
1
the lifting column brackets with the
hardware included. Connect all four
brackets using the pre-drilled holes
in the back panel.
D Nut Inserts, 5/16"-18 x 5/8"
X8
Flat Washer 1/4" ID 9/16" OD
X10
Hex Head Screw, 5/16"-18
X10
Preparing The Lifting Columns
Lifting column is pre-installed with M6 x 10 bolt.
1
Insert lifting column into the keyway on the
framework then lock in place from the side
by attaching with M6 screw .
Wall Mount Height Adjustable Mesa Assembly
Adjust the framework to the
1
distance between the lifting column brackets.
Slide the assembled lifting columns and framework in to the
assembled lifting column brackets on the back panel.
2022 R1
Flat Head Screw, M6x12
X4
x
BRC GROUP • www.brc.group • info@brc.group • 877.260.4309
Lifting Column Brackets
Install cantilever support with screw and
2
star washer to framework.
Flat Head Screw, M6x12
X4
Socket Head Screw, M6x16
X8
Star Washer, M6 X8
Installation Guide
Installation Guide
Connect the lifting columns
2
to the bottom bracket using
screws and star washers.
Page 1 of 3