BRC Mesa Adaptive Wall Mount Electric HA Table Installation Manual

| Mesa Adaptive Wall Mount Electric HA Table
This guide assumes that the wall mounting surface is level and plumb. Mounting into wood wall studs or concrete is recommended. For metal wall studs or otherwise,
sufficient support must be added to accommodate heavy loads. Contact your BRC representative for weight limit requirements and recommendations.

Preparing The Wall Panel

Align the mounting holes in the modesty brackets
1
with the lifting column supports and the rear wall
panel. Orient the modesty brackets as shown with
tab hooks towards the inside. The lifting column
supports and modesty brackets are universal right
and left. Attach using provided washers and bolts.
D Nut Inserts, 5/16"-18 x 5/8"
X8
Flat Washer 1/4" ID 9/16" OD
X8
Hex Head Bolt, 5/16"-18
X8

Preparing The Lifting Columns

Lifting column is pre-installed with M6x10 bolt.
1
Insert lifting column into the keyway on the
framework then lock in place from the side
by attaching with M6 screw.

Wall Mount Height Adjustable Mesa Assembly

Adjust the framework to
1
the distance between the bases.
Slide the assembled lifting columns and
framework in to the base attached to
the back panel.
2022 R1
Flat Head Screw, M6x12
X4
x
BRC GROUP • www.brc.group • info@brc.group • 877.260.4309
Wall panel
Modesty
Brackets
Lifting Column
Supports
Install cantilever support with screw and
2
star washer to framework.
Flat Head Screw, M6x12
X4
Socket Head Screw, M6x16
X8
Star Washer, M6 X8
Installation Guide
Connect the lifting columns
2
to the bottom of the base
using screws and star
washers.
Page 1 of 3