Download Print this page

BRC NoLita Assembly Instruction Manual

Download this manual

NoL ta Assembly Instruction

Need help?

Do you have a question about the NoLita and is the answer not in the manual?

Page 1 NoL ta Assembly Instruction...
Page 2 POSITION THE FRONT AND RETURN BASE AS SHOWN BELOW, SO THAT THE CONNECTION POINTS WILL BE IN FRONT OF EACH OTHER FRONT BASE RETURN BASE REMOVE ALL TRIMS EXCEPT FOR THE FRONT (MODESTY) TRIM.
Page 3 REMOVE ALL PANELS. FIRST MOVE THEM UP, AND THEN PULL THEM BACK. CONNECT THE TWO FRAMES TOGETHER USING THE HARDWARES SHOWN BELOW. MAKE SURE THEY ARE ALL TIGHTEN WELL.
Page 4 CONNECT THE STRAIN RELIEF AROUND THE COILED CABLE. PLACE THE STRAIN RELIEF IN THE SPECIFIED LOCATION ON THE WIRE MANAGER BRACKET. CONNECT THE WIRE MANAGER BRACKET TO THE SPECIFIED LOCATION WITH THE PROVIDED SELF TAPPING SCREWS. THEN SECURE THE COILED CABLE BY TIE WRAP ING IT TO THE BOTTOM OF THE BASE THROUGH THE SPECIFIED HOLES.
Page 5 LEVEL THE BASE USING THE LEVELERS UNDER EACH LIFTING COLUMN. LEVELERS PLACE THE WORK SURFACES ON THE TOP FRAMES AND ALIGN THEM USING THE PILOT HOLES. PILOT HOLES SHOULD BE ALIGNED WITH END BRACKET HOLES. ALL WORK SURFACES ON ONE SIDE HAVE 3 PILOT HOLES AND ON THE OTHER SIDE ONLY 2.
Page 6 PLEASE FOLLOW SEQUENCE AS SHOWN TO CONNECT CABLES. SWITCH CABLE MOTOR CABLE DL6 POWER CORD MOTOR CABLE DL6 For more information contact: marketing@brc.group 24 Armstrong Ave Georgetown, ON L7G 4R9 Phone: 905.873.8509 brc.group Toll Free: 1.877.260.4309 info@brc.group...