Quick Guide (English) - Panasonic VDR-D158GK Quick Manual

Quick guide (English)

Quick guide (English)
Power supply
Charging the battery
When this unit is purchased, the battery is not
charged. Charge the battery before using this
unit.
If the DC cable is connected to the AC
adaptor, then the battery will not charge.
Remove the DC cable from the AC adaptor.
1 Connect the AC cable to the AC
adaptor and the AC outlet.
2 Put the battery on the battery
mount by aligning the mark, and
then securely plug it in.
The output plug of the AC cable is not
completely connected to the AC adaptor
socket. As shown in
Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the
CHARGE lamp flashes and the
charging time will be longer than
normal.
116
LSQT1053
Push the battery against the
battery holder and slide it until it
clicks.
While sliding the
BATTERY RELEASE lever, slide the
battery to remove it.
, there is a gap.
Fitting the battery
Removing the battery
Hold the battery with your hand so it does not
fall.
Be sure to turn off the power on this unit and
check that the status indicator and the access
lamp are both off before removing the battery.