Table of Contents
Advertisement
Quick guide (English)
ª
Power supply
Charging the battery
When this product is purchased, the battery is not charged.
Charge the battery before using this product.
≥If the DC input lead is connected to the AC adaptor, then the
battery will not get charged. Remove the DC input lead from
the AC adaptor.
1
Connect the AC mains lead to the AC adaptor and the AC
mains socket.
2
Put the battery on the battery mount by aligning the
mark, and then securely plug it in.
Charging lamp
Lights up: Charging
Goes off:
Charging completed
Flashing:
The battery is over discharged (discharged
excessively). In a while, the lamp will light up and
normal charging will start.
When the battery temperature is excessively high
or low, the [CHARGE] lamp flashes and the
charging time will be longer than normal.
Fitting the battery
Push the battery against the battery holder and slide it until it
clicks.
Removing the battery
While pushing the [PUSH] button, slide the battery to remove it.
PUSH
≥Hold the battery with your hand so it does not fall.
ª
Inserting/removing a cassette
1
Slide the [OPEN/EJECT] lever and open the cassette
cover.
≥When the cover is fully opened, the cassette holder will come
out.
2
After the cassette holder is opened, insert/remove the
cassette.
≥When inserting a cassette, orient it as shown in the figure,
and then securely insert it as far as it goes.
≥When removing, pull it straight out.
3
Push the [PUSH] mark 1 in order to close the cassette
holder.
1
PUSH
4
Only after the cassette holder is completely housed,
close the cassette cover.
39
VQT0S78
Advertisement
Table of Contents
