Manual
8
EIM 316/336 interface application for setup and configuration of MMIMyK
6.6 Manual control
The valve can be opened and closed by manually
setting an opening degree, while the controller is in
manual control mode. It is possible to set the
controller in manual control mode, by pressing
enter on the manual control screen. This selects the
manual control setting. Pressing enter again, makes
it possible to toggle the manual control setting on
or off, by pressing the up or down buttons.
6.7 Readouts
The readout screen shows some of the important
readout values, read from the controller.
This includes the current superheat, superheat
reference, current opening degree etc.
DKRCC.PS.RQ0.C2.02 / 520H8422
After setting the manual control mode to on,
press enter to accept the change. It is now
possible to select the manual opening degree,
by pressing the down button and pressing enter.
Using the up or down buttons, the wanted
opening degree can now be set. Pressing enter
accepts the opening degree, and the valve will
open or close to the selected opening degree.
© Danfoss A/S (AC-MCI/sw), 2014-03