Nokia CR-82 Manual page 4

Set up
You can use a compatible charger
with a mobile device that is placed
in the mobile holder. The mobile
holder is supplied with two nuts of
different sizes. If the arms of the
mobile holder cover the side keys of
your mobile device when using the
preinstalled nut, use the other nut
instead.
Push the release buttons at the
sides of the holder to expand the
arms to the maximum width (2).
If the charger connector is located
at the bottom of your mobile
device, remove the locking catch by
pulling it from the holder, and push
the nut through the ring to detach
it (3A). Insert the charger cable into
the slot in the nut (3B). Push the
nut into the ring (3C). Attach the
locking catch (3D).
4 Copyright © 2007 Nokia. All rights reserved.
If the charger connector is not
located at the bottom of your
mobile device, remove the locking
catch, and push the nut through
the ring (4A). Loop the charger
cable onto the nut (4B); adjust the
charger plug so that it reaches to
the charger connector on your
mobile device. Push the nut into the
ring (4C). Attach the locking catch
(4D).