Table of Contents
Advertisement
WELCOME TO THE LECTRIC EBIKES FAMILY
Thank you for purchasing a Lectric eBike.
Please read this Owner's Manual carefully before setting up your
bicycle and riding. You should become thoroughly familiar with the
proper operation of your Lectric eBike, its features, capabilities, and
limitations. To ensure a long, trouble-free life for your Lectric eBike,
provide it with the proper care and maintenance as described in this
manual. Of course, it is not practical or possible to warn you about all
of the hazards associated with operating or maintaining your Lectric
eBike. For this, you must use your own good judgment.
For replacement parts and accessories, you should always use
Lectric eBikes approved parts, as they have been specially
designed for your bicycle and manufactured to meet Lectric eBikes'
demanding standards.
This manual should be considered a permanent part of your bicycle
and should remain with the bicycle when it is sold.
If you need any assistance, please do not hesitate to reach out to us.
CONTACT INFORMATION
Email: contact@lectricebikes.com
Website: lectricebikes.com
Phone: (602) 715-0907
Please record your bicycle's serial number in the space below. The
serial number is located on the head tube of your bicycle. Refer to
page 13 for the location of the serial number.
SERIAL NUMBER
L E CT R I C E B I K E S.C O M | 602.715.0907
2
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the XP Lite and is the answer not in the manual?
Questions and answers
Resetting the odometer
To reset the odometer on a Lectric XP Lite, hold the plus (+) button for 5 seconds.
This answer is automatically generated
how to properly install chain guard?
To properly install the chain guard on a Lectric XP Lite:
1. Remove the six screws around the perimeter of the pulley belt guard and take off the front part of the guard.
2. Use an 8 mm hex wrench to unscrew and remove the crank bolt.
3. Use a crank puller tool to remove the pulley.
4. Remove the rear part of the belt guard.
5. Place the new chain guard behind the chain stay.
6. Line up the front mounting tab with the mounting point behind the pulley and insert a 4 mm bolt.
7. Line up the rear mounting tab with the rear mounting point on the chain stay and insert another 4 mm bolt.
8. Reinstall the pulley, crank, and belt.
This process requires removing existing parts and using specific tools like a crank puller and hex wrench.
This answer is automatically generated
Serial number on XP Lite 2.0