Advertisement
7. Turn on control. Make sure all the motors are running clockwise
(spindle motor, hydraulic motor, cross-feed motor, vertical rapid motor,
and coolant pump motor). 1) Release (pull) emergency button. (See
Fig. 1) 2) Press spindle (See Fig. 2 & 3), hydraulic (See Fig. 4 & 5)
and dust suction and coolant system buttons (See Fig. 6 & 7). to check
rotation. 3) Check cross-feed motor by toggling in and out switch while
function switch is in manual mode (See Fig. 8). 4) Check rapid vertical
motor by pressing up button to take out the spindle support block and in
the mean time down push buttons while function switch is in manual
surface or plunging mode (See Fig. 9).
Function Switch
Emergency Button
Rapid Up/Down
Push Button
4
Spindle On Button
Hydraulic On Button
Advertisement
