How To Program The Sr60 Scanner; What Is Programming Mode; What Is A Programming Session - Intermec SR60 Programmer's Reference Manual

How to Program the SR60 Scanner

What Is Programming Mode?

What Is a Programming Session?

SR60 Scanner Programmer's Reference Manual
Chapter 1 — Learning About Programming the SR60 Scanner
There are two ways for you to program the scanner:
• You can scan programming bar codes to modify the scanner's
programmable features and options. This manual provides the
bar codes and instructions necessary to configure the features
and options. To ensure full compatibility and proper
function, use only the programming bar codes in this manual.
• You can send commands directly from the host. A limited set
of host commands are available. For help, see "RS-232 Host
Commands" on page 163.
When you program the scanner, the scanner stores the changes
until reprogrammed or returned to factory defaults.
The scanner must be placed in Programming mode in order to
accept programming commands. You place the scanner in
Programming mode by scanning the SET bar code, which
appears first in each set of programming bar codes in this manual.
While in the Programming mode, the scanner recognizes only the
special programming bar codes contained in this manual.
To understand how the LEDs and beeper behave while the
scanner is in Programming mode, see "About the Scanner LEDs
and Beeper" on page 7.
A typical programming session is conducted as follows:
1 Scan the SET bar code at the beginning of each set of
programming bar codes to place the scanner in Programming
mode. The scanner emits three beeps, indicating it has read
the bar code, and the green LED flashes on and off slowly
while the scanner remains in Programming mode. Normal
scanning functions are disabled.
2 Scan the programming bar codes that are specially encoded to
make changes. With few exceptions, the scanner emits a triple
beep each time you scan a valid bar code. Be aware of these
considerations:
3