Carry out the steps in the
7.
Home Connect app to connect the
appliance.
a If the display shows con and
lights up permanently, the appli-
ance is connected to the home
network.
If the display shows Home Con-
8.
nect Error, the appliance is not
connected to the home network.
Check whether your appliance is
‒
in range of your home network.
Reconnect the appliance to the
‒
WLAN home network (Wi-Fi)
with WPS function.
"Connect your appliance to the
9.
Home Connect app" → Page 45.
Connecting your appliance to
the Home Connect app
Requirements
¡ The appliance is connected to the
WLAN home network (Wi-Fi).
¡ The Home Connect app is open
and you have logged on.
Set the programme to position 3.
1.
a The display shows APP.
Press
.
2.
a The appliance connects to the
Home Connect app.
Once your appliance is displayed
3.
in the Home Connect app, carry
out the last steps in the
Home Connect app.
a If the display shows con, the appli-
ance is connected to the
Home Connect app.
Activating Wi-Fi on the appli-
ance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold
1.
seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press
repeatedly until the dis-
3.
play shows on.
a Wi-Fi is activated.
Deactivating Wi-Fi on the ap-
pliance
Press and hold
1.
three seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press
repeatedly until the dis-
3.
play shows oFF.
a Wi-Fi is deactivated.
Note: If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
Software update
Requirement: The display shows .
Press and hold
1.
seconds.
Set the programme to position 6.
2.
a UPd appears on the display.
Press
.
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
Resetting the appliance net-
work settings
Press and hold
1.
3 seconds.
Home Connect en
for approx. 3
for at least
for approx. 3
for at least
45