Jocel JLR013934 Instruction Manual page 64

Self-cleaning of drum (once a month is recommenced)
After using for a long time, there may be stains in the washing drum. The self-cleaning program can be
used to clean the exterior and the interior of the drum.
Notes: During self-cleaning, do not add clothes or detergents.
Cleaning the universal coupling (once every six months is recommended)
1. Remove the water supply hose from the universal coupling.
2. Screw off the fastener by following the arrow.
3. Rinse the interior of the fastener with water.
4. Install the clean fastener and the water supply hose.
Cleaning the inlet valve (once every six months is recommended)
1. Remove the water supply hose from the washing machine.
2. Take out the filter screen from the inlet valve.
3. Clean the filter screen thoroughly with a toothbrush or similar tools.
Install it to the inlet valve.
4. Connect the water supply hose again.
Cleaning the filter of the drainage pump (once a month is recommended)
1. After drainage, disconnect the power plug, press the clip above the decorative cover for the drainage
pump at the right corner in the front of the body, and open the filter cover.
(Note: if there is hot water in the washing machine, please take the above actions only after cooling.)
2. Pull out the emergency drain hose, and remove the plug at one end. After the water drains away, insert
the plug and push back the emergency drain hose.
3. Screw off the filter anti-clockwise.
4. Rinse the filter thoroughly with water.
5. Insert the filter, screw it clockwise and close the decorative cover for the drainage pump.
Notes:
a. The filter must be tightly screwed to prevent water from leaking;
b. Do not clean the filter when a program is running.
64