Jocel JLR013934 Instruction Manual page 54

Requirements for installation place
Horizontal adjustment:
•
The tilt angle shall not exceed 1 degree.
Power outlet:
Do not connect to a number of power plugs.
Installation place:
•
Allow sufficient safety distance between the washing
machine and the wall. (distance between the back/left/
right of the washing machine and a wall >2cm)
•
Install the washing machine at a hard and flat floor with
a drain. Do not install it on soft carpeted or wooden
floors.
•
Do not put clothes to be washed or other objects at the
worktop of the washing machine because they will
affect the running of programs.
Notes
Connecting the power supply
1. Do not use a power strip or power strip bar.
2. If the power cord is damaged, please contact professional persons to repair it to avoid injuries.
3. After using, please unplug the power plug and turn off the faucet.
4. Connect the power cord of the washing machine to a grounded power outlet and follow the wiring rules.
5. The washing machine shall be installed at a place where it can connect to the power outlet easily.
• The washing machine shall be repaired by professional persons. Non-professional persons may damage
the washing machine seriously or cause serious faults during repair, please contact the local repair
center.
• Do not place the washing machine at a place whose surrounding temperature may be below 0 °C
because water pipes will be frozen and broken and the program controller will be damaged at the
temperature below 0 °C.
• If the washing machine is handled in winter at the temperature below 0 °C, please place it at room
temperature several hours before using.
Connecting the power supply
• The washing machine must have a grounding device. The grounding device can reduce the danger of
electric shocks in case of a failure. This device has a grounding line (a conductor with a grounding plug).
The grounding plug must be inserted into an appropriate power outlet.
• Please contact professional persons to test whether or not the washing machine is grounded correctly. If
the power outlet and the power plug do not match, please do not change the power plug.
• If the washing machine smokes or emits a peculiar smell, please cut off the power supply and contact
professional persons.
To ensure quality, the washing machine is filled with water for testing at the factory, water may remain in the
interior of the drum, the door seal and the door glass, and this is a normal condition.
54