Jocel JLR013934 Instruction Manual page 55

Connecting the water supply hose
1. The water supply pressure shall be from 30kPa to 850kPa.
2. During connection of the water supply hose and the inlet valve, do not
screw them tightly to avoid slipping.
•
There are 2 seal rings in connectors at both ends of the water supply
hose to prevent water from leaking;
•
Turn on the faucet to check the connectors for any water leakage;
•
Check the water supply hose regularly and replace it if necessary;
•
Make sure that the water supply hose is not warped or damaged
Installation and connection of the inlet hose
1. Unscrewing the part "a" from the water faucet. (As figure 1).
2. Attach the water inlet hose to the water faucet. (As figure 2).
NOTE: Do not overtighten. Damage to the valve can result.
3. Run water through faucet and inlet hose into a bucket or laundry tub, to get rid of particles in the water
line that might clog the inlet valve screen.
4. Attach the hose connected with the water faucet to the water inlet valve. (As figure 3).
Make sure a washer is at the inlet hose seat, or leakage will occur.
NOTE: Do not overtighten. Damage to the valve can result.
5. Check for leak
(1) Swing the water inlet hose gently to confirm if it's suitable.
(2) Turn on the water faucet and check for leak. A small amount of water might enter the machine. You
will drain this later.
55