GE PACSystems RXi Box IPC User Manual page 27

5. Remove the RTC battery from the retaining clip, being careful to not bend the positive
terminal clip.
RTC Battery
Use of a different type of battery than that specified here may present a risk of
fire or explosion.
Battery may explode if mistreated. Do not recharge, disassemble, heat above
100°C (212°F) or incinerate.
Note: For proper disposal, refer to Battery Disposal document 82A1540-MD01.
6. Install the new battery in the retaining clip.
The replacement battery must be IC690ACC001 from GE Intelligent Platforms.
Install the battery with the positive (+) side up. That is, with the + side away from the
circuit board. The coin cell must be inserted at an angle to go under the positive terminal
clip and then slid into the carrier and snapped into place.
7. Replace and secure the interior lid with four Phillips-head screws.
8. Replace the front panel on the IPC and hand-tighten the four screws to secure it.
22
Hardware Installation
Warnings
PACSystems* RXi Box IPC GFK-2785C