Table of Contents
Advertisement
4.A) END STOP ASSEMBLY
WARNING
Trolley stops (clip angles) or end stop assemblies
must be installed on both ends of the bridge beam to
prevent hoist trolley from running off the end of the
beam, which could result in injury to the operator and
others and damage to the load and other property.
4.B TROLLEY STOPS SUPPLIED BY CUSTOMER
BRIDGE BEAM
FLANGE WIDTH
3 5/8 TO 4
3 1/2 X 3 1/2 X 1/2
4 1/8 TO 6 1/4
6 5/8 TO 8 1/4
8 5/8 TO 10 1/2
10 5/8 TO 13
A COPED GIRDER CONNECTION IS SHOWN FOR ILLUSTRATION PURPOSES ONLY.
ACTUAL GIRDER CONNECTION ARRANGEMENT MAY DIFFER BY APPLICATION.
28
TROLLEY STOPS
ANGLE SIZE
4"
5 X 3 1/2 X 1/2
6 X 3 1/2 X 1/2
7 X 4 X 1/2
LONGEST SIDE OF ANGLE MOUNTED
PERPENDICULAR TO GIRDER WEB
8 X 4 X 1/2
WARNING
If bridge crane is mounted on an open-
end runway rail, then end stops must be
installed to prevent bridge crane from
running off the end of the runway rail
resulting in injury to the operator and
others and damages to the load and other
property. End stops for the trolley must
also be installed.
P/N: C11746308 REV. AB June 2022
Advertisement
Table of Contents
