Step 1: Notching Girder At Ends (As Required); Step 2: Mounting Girder On Support (As Required) - Yale SHAW-BOX YK Series Assembly & Instruction Manual

STEP 1:
NOTCHING GIRDER AT ENDS (AS REQUIRED)
STEP 2:
MOUNTING GIRDER ON SUPPORT (AS REQUIRED)
NOTCH CUT AT BOTH ENDS OF THE GIRDER,
SMOOTHE THE BURNED AREA BY GRINDING.
A COPED GIRDER CONNECTION IS SHOWN FOR ILLUSTRATION PURPOSES ONLY.
ACTUAL GIRDER CONNECTION ARRANGEMENT MAY DIFFER BY APPLICATION.
Check your confi guration to see if a capping channel is required.
A COPED GIRDER CONNECTION IS SHOWN FOR ILLUSTRATION PURPOSES ONLY.
ACTUAL GIRDER CONNECTION ARRANGEMENT MAY DIFFER BY APPLICATION.
18
*REFER TO STEP 7 FOR VALUES OF F & G
USING TORCH OR PLASMA BURNER AND
P/N: C11746308 REV. AB June 2022