Software Identifi - Cation - Intermec EasyCoder E4 Important Information

Important Information
Software Identifi -
cation
1
/. The printer should always be
switched off while a peripheral
device is connected or discon-
nected.
4
Check the correctness of program fi les in the printer this way.
For the EasyCoder F2 and F4 family:
To verify the fi rmware used in printer, follow the sequence below.
- Connect a PC to the serial port of the printer instead of a scale
- Start a terminal program.
- Set PC to 9800 baud, 8 bit, parity none, 1 stop bit.
- Type: ? VERSION$
- Verify the fi rmware number shown in the terminal window.
To verify the fi les stored in the printer.
- Connect a PC to the serial port of the printer instead of a scale
- Start a terminal program.
- Set PC to 9800 baud, 8 bit, parity none, 1 stop bit.
- Type: FILES
- Check fi le size of all layout fi les (suffi x .LAY). Type: RUN "cksum
xxx.LAY" for each layout fi le presented by the FILES command.
Note size and checksum.
- To examine and verify contents, type: Copy xxx.LAY, "uart1:"
xxx is substituted for each filename listed by the FILES
command.
- This will send a stream of ASCII data to the host screen.
For the EasyCoder E4:
To verify the fi rmware used in printer, follow the sequence below.
- If the printer is on, switch it off.
- While powering on, press the <Feed> button on printer's front.
When printer start fl ashing the LED, release the button.
- Wait until confi guration label has been printed.
- Tap the <Feed> button again to restore printer to normal
operating mode.
- Verify the fi rmware number printed on the label.
To verify the fi les stored in the printer.
- Connect a PC to the serial port of the printer instead of a scale
- Start a terminal program.
- Set PC to 9800 baud, 8 bit, parity none, 1 stop bit.
- Type: FILES
- Check fi le size of all layout fi les (suffi x .LAY).
- To examine and verify contents, type: Copy xxx.LAY, "uart1:"
xxx is substituted for each filename listed by the FILES
command.
- This will send a stream of ASCII data to the host screen.
Intermec Scale-Connected Printers – Important Information Ed. 1
1
.
1
.
1
.