Advertisement
4
将橡胶垫片（F），不锈钢垫片（G）穿过通牙螺管，将固定螺母
（I）锁紧在通牙螺管（O）上，在用螺丝刀将两颗螺钉（H）锁紧
在固定螺母（I）用以紧固。
Put gaseket (F), mounting washer (G) through mounting tube. and
thread mounting nut (I) to the mounting tube (O), thread two screws
(H) to mounting nut (I) for tightening.
6
出水管
outlet tube
1. 将快速接头（E）的一端插进出水管上，按下上端的按钮将快
速接头（E）锁紧.
2. 另外一端将抽拉软管接头插进快速接头（E）并按下按钮将快速
接头锁紧。将配重块（D）安装在靠近龙头（A）一端的抽拉软
管上 （C）。开水检查龙头是否漏水。
1. Put Quick Connector (E) to outlet tube and press the button on
the quick connector (E). 2. The other end of pull-out hose to
quick connector (E), press the button to lock. Install the Hose
Weight (D) on the Pullout Hose (C) near the end of the Faucet
(A). turn on the water and check for leak.
5
O
将抽拉软管（C）从龙头（A）穿过去（带内螺纹的端方向朝上），
将喷头（B）拧紧在抽拉软管（C）上。
Put pull-out (C) hose through Faucet (A). (side with hex nut towards
upside). commect Spary Wand (B) to the side with hex nut of pull-
out hose (C).
7
将去水组件（L）按如图所示顺序安装。注：水塞底部接口要与去水
组件接口平行。
Install the Drain Assembly (L) in the order shown in the figure.
Note: The bottom interface of the plug should be parallel to the
Drain Assembly interface.
4
水塞
Plug
Advertisement
