Advertisement
8
拨杆
Lever
将线控组件（K）带有螺母的一端插入提拉面盖（N）旋紧固定，
再将提拉杆拧进装饰板的小孔中旋紧固定。将线控组件（K）的拨
杆调至低位, 对准孔位将其插入去水组件 ( L )，顺时针旋紧固定。
Insert the end of the Rope Drain (K) with the nut into Lift Rod
Escutcheon Assembly (N) and screw the Lift Rod into the small
hole into the Lift Rod Escutcheon Assembly (N) to tighten it .Turn
the lever of the Rope Drain (K) low , align it and insert it into the
Drain Assembly (L), tighten it clockwise.
使用说明 Function Instruction
1. 抽拉水嘴检验升降是否平稳自如，水嘴抽拉到使用理想的位置不会
自动滑落。
2. 喷头的水型可以切换，当连续按下按钮时为喷洒水型，松开后为普
10
通水型。
A
提拉杆
Lift Rod
N
9
8
注意：将线控组件（K）插入时，要对准卡扣再内推。然后再顺时
针旋紧。
Attention: When inserting the Rope Drain (K), align the snap and
push in. And then tighten it clockwise.
1. Please check whether the spout could be pulled out smoothly and
could locate at the desired height in puling range without dropping.
2. Switch the flow pattern from regula aerated flow to spray flow
by pressing the switch button on the spray wand.
B B
B
普通水型
Regular Flow
5
INS10634C - 11/18
按钮
Button
喷洒水型
Spray Flow
Advertisement
